Roofing dumpster rental in Salt Lake City
Need a roll-off dropped fast after your Salt Lake City roof tear-off? We set the container, haul it away when you’re done.
Roofing Tear-off Dumpster Sizing by Squares
How big a roll-off do you actually need for a 25-square tear-off in Salt Lake City? Our rule is simple: one asphalt shingle square equals two-thirds of a cubic yard. Most jobs fit a 20-yard container; the low-wall design helps with loading. Consider the total tonnage; we track weights to keep your project within the limit.
15-Yard Roofing Dumpster
- Capacity: 15 cubic yards
- Fits: 15–20 squares of asphalt shingle
- Best for: Single-layer ranch and bungalow tear-offs
Our 10-yard can fits a tight driveway for small tear-offs while keeping shingle weight under the single haul limit.
20-Yard Roofing Dumpster
- Capacity: 20 cubic yards
- Fits: 25–30 squares of asphalt shingle
- Best for: Most two-story residential tear-offs
The 20-Yard Container is our roofing workhorse, featuring low side walls so crews can ground-throw shingles with ease.
30-Yard Roofing Dumpster
- Capacity: 30 cubic yards
- Fits: 35–45 squares of asphalt shingle
- Best for: Multi-layer tear-offs and small commercial roofs
Use the 30-Yard or 40-Yard container for big roof tear-offs to avoid a second haul-out.
Asphalt Shingle Weight and Tonnage Planning
A three-tab shingle weighs about 250 pounds per square; architectural laminate runs closer to 400. A 25-square tear-off can hit three to five tons before underlayment, so hooklift trucks use lower-side-wall roofing dumpsters to stay under weight limits. A 10-Yard Container tops out at 2 tons of standard roofing debris, but shingles can push past it fast. Heavier loads need a 20-Yard Container with a reinforced roofing dumpster rental set via hooklift.
When you mix shingle debris with framing or sheathing offcuts, we route that container to our standard c&d debris service—keeping your job site compliant. Pure asphalt tear-offs, meanwhile, stay on our simplified roofing lineup for easier, direct disposal.
Driveway Placement for Roofing Crew Workflow
We angle the swing-door end of each roll-off directly toward the active eave; this allows your crew to ground-throw shingles rather than walking every armload around the house. We always use wooden planks as driveway boards under the rollers before the container touches concrete in Salt Lake City. After checking roof tear-off container sizing, review the asphalt shingle disposal best practices guide to ensure your six-foot tarp perimeter makes the final nail sweep effective.
Drop angle
Rear door toward the roof line
Set the swing-door end facing the eave where the crew works so walk-in loading and ground-throw share the same path.
Surface protection
Wooden planks under every roller
Loaded shingle weight can gouge concrete; driveway boards stay under the rear rollers for the full rental window.
Sweep zone
Six-foot tarp perimeter
Stage magnetic sweepers on the tarp side so nail cleanup runs in parallel with loading the heavy debris.
Tile, Slate, and Metal Roof Tear-off Containers
Concrete tile, natural slate, and standing-seam metal punish a container that was not built for the load: these materials weigh two to four times what asphalt does per square. For these jobs, we route in a 30-yard bin featuring reinforced sides and a heavier floor plate; we also cap the fill volume below the visual rim so the Lowboy maintains legal axle weight. We also assist with a general construction debris service for mixed loads.
Same-day Pickup for Fast Roof Project Turnover
Tear-offs run tight schedules; we pull the roll-off on the crew’s demobilization window so the container swap-out frees the driveway for inspection or gutter reinstall before the homeowner walks the site; Salt Lake City crews dispatch same-day haul-out every afternoon!